Ok guys and gals, l thought l'd put some information up regarding all the parts required to carry out a Phase 1 to Phase 2 front end conversion. In this case, the conversion was phase 1 225 to Phase 2 R26.
Please note that this conversion is only for non-xenon headlighted phase 1 vehicles.
Here is the list of parts required to complete the conversion.
The Phase 2 RS bumper consists of four part numbers:
77 01 477 043 - bumper + grilles = £327.39 + vat (£384.68)
77 01 477 197 - bottom undertray plate = £60.46 + vat (£71.04)
82 00 473 512 – rubber edge (also known as cup splitter) = £60 + vat (£70.05)
77 01 209 111 - air diffusers inside the bumper (for FMIC) = £23.37 + vat (£27.46)
The air duffusers are the parts which direct air into the FMIC so you may not require these if you intend to carry this out on a non-renaultsport Phase 1 vehicle or have an uprated FMIC.
The mounting for the phase 2 headlights is different to phase 1, therefore you will require the following additional parts:
82 00 412 348 - phase 2 bumper support left = £19.45 + vat (£19.45)
82 00 412 349 - phase 2 bumper support right = £19.45 + vat (£19.45)
The headlamp washers will only be required if you're considering this conversion for a non-renaultsport Phase 1 vehicle as you might not have these already.
82 00 082 370 – headlamp washer (each) = £9.39 +vat (£11.03)
The headlamp units required are as follows:
Right Hand Drive
77 01 063 222 – phase 2 halogen headlight left
77 01 063 223 – phase 2 halogen headlight right
These can be found relatively cheaply here:
https://www.crashrepairparts.com/pane...lt_megane_2006If you intend to carry out this conversion on a left hand drive non-uk vehicle you will require the following parts
Left Hand Drive
77 01 063 218 - phase 2 normal headlight left
77 01 063 220 - phase 2 normal headlight right
Further help in removing and re-fitting of bumpers can be found here:
https://meganesport.net/bumperandintercoolerguide.htmThe Car As Is Now
pic taken at the FCS 22/6/2008
stevie