I have got the problem of no number plate lights on both sides.
I have checked fuses and all of the other side lights are working.
Any ideas
Number plate lights
Moderators: q292u, Ray, AndyAdmin, Stranger
- ikhan
- Advanced Driver
- Posts: 524
- Joined: Sun Sep 12, 2010 10:02 pm
- Currently Drives:: Megane 1.5 DCi (106)
Re: Number plate lights
If the bulbs are definitely ok, check for corrosion on the numberplate light units (connector / light housing etc.).
Renault Megane 1.5dCi (106)
Lowered 45mm (Spax)
RenaultSport R26 Front & Rear Bumpers, Spoilers, Door Bullets, & Exhaust
6000k HIDs (H7 & H11), LED Side, No Plate, & Interior Lights
18" Inovit Tarmac Alloys (matt black)
Lowered 45mm (Spax)
RenaultSport R26 Front & Rear Bumpers, Spoilers, Door Bullets, & Exhaust
6000k HIDs (H7 & H11), LED Side, No Plate, & Interior Lights
18" Inovit Tarmac Alloys (matt black)
- almcgrail
- Pass Plus
- Posts: 194
- Joined: Thu Oct 06, 2011 8:54 pm
- Currently Drives:: Megane II tourer 130
Re: Number plate lights
Also check the wiring at the hinge of the tailgate, mine had snapped and had done number plate light, heated rear window, wiper and boot lock. It was only until boot lock went that I got them all sorted.
Mine is sport tourer though.
Mine is sport tourer though.
-
- Posts: 1
- Joined: Sat Sep 14, 2013 11:26 pm
- Currently Drives:: 03 Megane with a dashboard like a Christmas tree
Re: Number plate lights
Almcgrail, out of interest how did you make good the snapped wiring? I've got the same issue though at the moment only affecting the boot lock + switch. There doesn't seem to be enough slack in the wiring to cut out the bad bits and rejoin with connectors. Any help appreciated. Thanks.
- almcgrail
- Pass Plus
- Posts: 194
- Joined: Thu Oct 06, 2011 8:54 pm
- Currently Drives:: Megane II tourer 130
Re: Number plate lights
Sorry only just seen this.
Open hatch and splice cable housing (top left), expose broken wires and solder in a longer piece. I split an old ISO cable to retain colours. Check for other potential breaks as I've had loads break but the extra piece I've added in means I haven't had to do one twice. Hope this helps.
Open hatch and splice cable housing (top left), expose broken wires and solder in a longer piece. I split an old ISO cable to retain colours. Check for other potential breaks as I've had loads break but the extra piece I've added in means I haven't had to do one twice. Hope this helps.
Return to “Problems / Questions”
Who is online
Users browsing this forum: No registered users and 33 guests