DASH kit

[borojono]

i am thinking about buying an alluminium dash kit from this company, i have a 53 reg megane, is the interior exactually the same as 05 upwards models https://www.edashkit.com/store/c/1205-Re ... -Kits.html also do you think i will pay import taxes,for buying from the US

[cactusbob]

Depends how they ship it and what they mark on the customs declaration. Ask them to mark it up with a $15 value then you may be OK

[ICEMAN]

you will have to pay VAT + Customs

VAT @ 17.5%
Customs @ 5%

eg.

A + 5% = B

B + 17.5% = cost to you.

its stupid.

but if u can get them to send it as a gift, you will avoid paying customs + VAT ( i think VAT might still be included)

[borojono]

damn looks like every place i look at seems to be expensive,it would look good as well as a brushed alluminium finish, has anybody seen any other places that sell them?

[borojono]

i finally got a alluminium dash kit from ebay, i will show you pictures when i get them,the kit goes around the centre console,also on the cd player,a strip across the full dash and on the air vents,hopefully they will look good

[borojono]

i got my dash kit installed,how do i put photos on here?

[Jonault]

Join a site called 'photobucket' and download your pictures to an album on their site.
Open a thread or a reply on this site and paste the web address of the picture or pictures that you want to show. Highlight the web address and click on the Img box that is an option for the message body when typing your message.
That doesn't sound very helpful when you read through it but it will make sense as you go through the steps.

John

[glen290]

Would like to see the result of this, may be easier that spraying the bits silver which is what i was planning to do

[borojono]

hi here are my photos
http://s184.photobucket.com/albums/x9/borojono/

[Basenji]

Was it difficult to apply it?
Zdrówko

[Jonault]

That looks rather tasty. How long did it take to attach?

[borojono]

about 25 minutes,you place each piece on the air vent and put heating on,just to soften the material,then peel 3M backing off,and put on you can stretch a little if needed.you get some alcohol to clean the surface,and some adhesive booster. looks nice especially the airvent part