HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

For all stuff related to modifying your car

Moderators: q292u, Ray, AndyAdmin, Stranger

User avatar
Nige
Advanced Driver
Posts: 277
Joined: Tue Jul 15, 2008 9:59 am
Currently Drives:: 03' Renaultsport Megane 1.4 16v...NO FAULTS HERE! :-D
Location: N.Ireland, Londonderry
Contact:

HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Nige » Thu Apr 22, 2010 5:57 pm

Hi Guy's

As by some demand a few people has asked me to put up photos of how i done my tail light conversion...here is a few snaps with details...

Hope this helps!

Phase 1 Lights
Image

Phase 2 Lights
Image

The Guide...

1. Firstly unscrew the tail lights from both sides and disconnect the plugs...

2. Cut the wires off plug off (Leave as much wire length as you possibly can! on all!)

3. Get these connectors...obtainable from maplin shops (you need 13) 6 for the passenger side/7 for the driver side(UK) vice versa for Left hand drive..
Image

4. Strip the wire back about 1cm each...and crimp the connector on the wire (with wire crimps, scissor like things)

5. Put electrical tape around the connectors apart from the bit your plugging in (obviously) to avoid shorts when plugging wires in side by side... you will see like i have done in the photos.

5. PASSENGER SIDE (UK CARS)
Image
From the images (ALL BLACK WIRES ARE GROUND)

Top Bulb = Fog (Does not work on this side UK CARS)
Pin 1 = Ground
Pin 2 = Nothing (Either pin dosent matter, dead anyway)

Lower Cluster (Refering to Picture)
Pin 1 (Top) = White (Reversing Light)
Pin 2 = White (Indicator)
Pin 3 = Black (Ground)
Pin 4 = Orange (Brake Light)
Pin 5 (Bottom) = Brown and Blue (Side Light's)

There is 2 white non-colour coded wires...dont be afraid to test as its trial and error...you may have to swap around...example...reversing light may be indicator bulb..you get the drift just swap pin 2 to 3, 3 to 2.....

DRIVER SIDE

There is now 3 white wires to deal with...again this is trail and error....you cant blow anything so dont be scared!! it's actually quite fun!

Image

Top Bulb = Fog (works on this side UK CARS)
Pin 1 = White
Pin 2 = Black (Ground)

Lower Cluster (Refering to Picture) (Same as passenger side)
Pin 1 (Top) = White (Reversing Light)
Pin 2 = White (Indicator)
Pin 3 = Black (Ground)
Pin 4 = Orange (Brake Light)
Pin 5 (Bottom) = Brown and Blue (Side Light's)

Happy Modding folks!!!! Enjoy!

Hope this helps you all! Really nice modification!! 30 min job
Last edited by Nige on Thu Apr 22, 2010 7:25 pm, edited 1 time in total.
Image
03' Megane 1.4 16v 3Dr, N.Ireland

thedools
Passed Theory
Posts: 29
Joined: Fri Mar 05, 2010 3:33 pm
Currently Drives:: '04 Renault Megane 1.9 Dci 120 Dynamique - 3 Door - Black - Lowered -45 - 225 bumpers - Tints - Alloys

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby thedools » Thu Apr 22, 2010 7:07 pm

Thanks for the post Nige, was going to ask you how you did yours :) got one rear light off ebay so ill be getting the other soon!
Megane 1.9 DCI 120, 3 dr, Black, Tints, HIDs, -45 Springs, 225 Bumpers, Alloys, Phase 2 rear lights, Carbon badge, LED Interior, French pressed plates

User avatar
Anthony
Rally Driver
Posts: 842
Joined: Mon Jun 15, 2009 6:52 pm
Currently Drives:: 2005 Renault Megane 1.5 dci 100
Location: Preston

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Anthony » Thu Apr 22, 2010 7:12 pm

Great post! :wor This should be made into a 'sticky'.
2005 1.5dci 100 Sport Hatch -Gone!

BlueMeganeII
Advanced Driver
Posts: 259
Joined: Wed Feb 03, 2010 11:21 am
Currently Drives:: 03 Megane 3 door 2.0 VVT Dynamique - Sunroof, 17" Alloys, Keyless Entry and start
55 Grand Espace Initial, Xenons, Leather, Sunroof, Keyless, Sat Nav, Tyre Pressure sensors, 18" Alloys, Roof spoiler/bars.
Contact:

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby BlueMeganeII » Wed Jun 23, 2010 2:50 pm

I wonder if people will start doing the Ph1 to Ph2 facelift like people did with the old Megane and Renault 19s.
Image

User avatar
Jammie667
Passed Theory
Posts: 45
Joined: Thu May 07, 2009 1:18 pm
Currently Drives:: Megane II Dynamique 1.9 DCI 120
Contact:

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Jammie667 » Tue Jul 13, 2010 9:22 am

wouldn't it make sense to mark all the white wires when you're taking the phase 1 lights to bits? Put little sticky labels on them so you know which lights they're for.
'04 1.9 DCI 120 Dynamique - 5Dr Hatch - Metallic Red
Bought 4th April 09
Image

User avatar
madwedge
Pass Plus
Posts: 160
Joined: Mon Aug 09, 2010 9:37 am
Currently Drives:: 2004 Renault Megane 2.0 litre 16v VVT Dynamique
Location: Southend-on-Sea

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby madwedge » Wed Aug 18, 2010 7:55 pm

Hi

I just wanted to link in this thread to the sticky too as it has additional info on Part Numbers, Looms and wiring etc.

Megane Facelift Rear light Cluster Part No's Here

I've found it a good read.

Thanks
Currently Driving: 2004 Renault Mégane Dynamique 2.0 litre 16v VVT

MacsMegane
Passed Theory
Posts: 35
Joined: Sun Jul 04, 2010 1:18 pm
Currently Drives:: 1.5dci Megane

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby MacsMegane » Tue Mar 08, 2011 9:30 pm

Good guide. I thought it would be a case of unplug one plug the new one in! What were Renault thinking?

User avatar
Sadret89
Advanced Driver
Posts: 412
Joined: Fri Sep 18, 2009 12:52 am
Currently Drives:: RENAULT MEGANE 1.5dci 80, INDUCTION KIT, 8K XENON HEADLIGHTS, 225 SPORT FULL BODY-KIT & EXHAUST SYSTEM, SOUND SYSTEM, TDI TUNING BOX, EDC BLACK STUFF FRONT BRAKE PADS

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Sadret89 » Fri Jun 10, 2011 11:21 pm

I'm just a little confused. Do you still keep the connector of the old lights and plug it into the new ones?
Check out the progress viewtopic.php?f=13&t=13676

davelowe
Driving Legend
Posts: 3136
Joined: Thu May 10, 2007 3:40 pm

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby davelowe » Sat Jun 11, 2011 9:40 pm

Good guide. Typical of Renault to use white for two different functions (oh and I think they are different from right to left too!). I found this out the hard way fitting a towing bracket and 12N trailer plug. Inside the car, I had to strip the insulation from one of the whites and meter it with brake/indicator/etc on to tell one from the other.

Personally, I prefer the look of the phase 1 lights (that nice slanting sidelamp)...
Silver 08 plate 5dr 1.5dci Dynamique 106 Tech Run (re-mapped)

Red 03 plate 5dr 1.9 Dynamique dci120

Best advice for Megane owners: sell it before it bankrupts you!

User avatar
Sadret89
Advanced Driver
Posts: 412
Joined: Fri Sep 18, 2009 12:52 am
Currently Drives:: RENAULT MEGANE 1.5dci 80, INDUCTION KIT, 8K XENON HEADLIGHTS, 225 SPORT FULL BODY-KIT & EXHAUST SYSTEM, SOUND SYSTEM, TDI TUNING BOX, EDC BLACK STUFF FRONT BRAKE PADS

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Sadret89 » Wed Jun 15, 2011 7:53 pm

These plug and play adaptors are available.

https://www.renaultpartsdirect.co.uk/ind ... ct_id=1694
Check out the progress viewtopic.php?f=13&t=13676

User avatar
Sadret89
Advanced Driver
Posts: 412
Joined: Fri Sep 18, 2009 12:52 am
Currently Drives:: RENAULT MEGANE 1.5dci 80, INDUCTION KIT, 8K XENON HEADLIGHTS, 225 SPORT FULL BODY-KIT & EXHAUST SYSTEM, SOUND SYSTEM, TDI TUNING BOX, EDC BLACK STUFF FRONT BRAKE PADS

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Sadret89 » Wed Jun 22, 2011 10:15 pm

I've fitted mine today, passenger side with a bit of trial and error which was in fact fun, perfect!
The drivers side I got it all to work except the side light doesnt work when lights are turned on but works when brake is pressed, any ideas?
Check out the progress viewtopic.php?f=13&t=13676

User avatar
Sadret89
Advanced Driver
Posts: 412
Joined: Fri Sep 18, 2009 12:52 am
Currently Drives:: RENAULT MEGANE 1.5dci 80, INDUCTION KIT, 8K XENON HEADLIGHTS, 225 SPORT FULL BODY-KIT & EXHAUST SYSTEM, SOUND SYSTEM, TDI TUNING BOX, EDC BLACK STUFF FRONT BRAKE PADS

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby Sadret89 » Wed Jun 29, 2011 12:53 pm

Anyone?
Check out the progress viewtopic.php?f=13&t=13676

User avatar
ikhan
Advanced Driver
Posts: 524
Joined: Sun Sep 12, 2010 10:02 pm
Currently Drives:: Megane 1.5 DCi (106)

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby ikhan » Sat Sep 10, 2011 4:15 pm

Did mine today - I must say it must have been the easiest mod so far, carried out in between attending the builder's as well.

Tail lamp and brake lamp are the easiest to do (as well as the earth) as the wires are the same colour on both plugs (assuming you use the plug off an car with the newer lights fitted as I did). It's the indicator, reverse, and fog lamp that you need to test for as the wires to these are all white!

I left the original plugs in place as well - I just used scotch lock connectors.
Renault Megane 1.5dCi (106)
Lowered 45mm (Spax)
RenaultSport R26 Front & Rear Bumpers, Spoilers, Door Bullets, & Exhaust
6000k HIDs (H7 & H11), LED Side, No Plate, & Interior Lights
18" Inovit Tarmac Alloys (matt black)

S1mbo1980
Posts: 1
Joined: Sat Aug 18, 2018 11:11 am
Currently Drives:: Megane mk 2

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby S1mbo1980 » Sat Aug 18, 2018 11:14 am

Does anyone out there make and sell direct plug and use replacement connectors to simplify the upgrade for the people that don’t like fiddling with their cars , anyone fancy making one for me I will pay

manymaniyaa
Posts: 1
Joined: Mon Mar 18, 2019 9:26 am

Re: HOW TO: Megane Ph 1 to Ph 2 Rear Lights Conversion...

Postby manymaniyaa » Mon Mar 18, 2019 9:32 am

thedools wrote:Thanks for the post Nige, was going to ask you how you did yours :) got one rear light off ebay so ill be getting the other soon! PhenQ | https://phenq-reviews.com

All of these are converted to the things you can't even modify


Return to “Modifications”

Who is online

Users browsing this forum: No registered users and 27 guests