Search found 182 matches
- Fri Dec 12, 2008 9:19 pm
- Forum: Parts and Accessories
- Topic: 6 speed fly wheel
- Replies: 4
- Views: 2584
Re: 6 speed fly wheel
Just the flywheel.. However You could try a Factor and see if they could get one cheaper..
- Thu Dec 11, 2008 2:01 pm
- Forum: Parts and Accessories
- Topic: 6 speed fly wheel
- Replies: 4
- Views: 2584
Re: 6 speed fly wheel
The "dual mass" flywheel that is fitted to you vehicle do fail over time/miles.. It is not that unusual but are not subject to any "recall" or "tech solution"..
A replacement is around £600ish.. Not including the price of the clutch..
A replacement is around £600ish.. Not including the price of the clutch..
- Tue Dec 09, 2008 5:44 pm
- Forum: Problems / Questions
- Topic: Megane Keyless Entry
- Replies: 2
- Views: 2130
Re: Megane Keyless Entry
Its a little fiddely to replace the sensor. And is not cheap at £200
Water gets in behind the sensor lense and shorts/damages the Led's..
Water gets in behind the sensor lense and shorts/damages the Led's..
- Mon Dec 08, 2008 7:57 pm
- Forum: Problems / Questions
- Topic: Headlight Levels
- Replies: 8
- Views: 4886
Re: Headlight Levels
So let me ask again, why did you take them off?? as it may be significant to my answer to the problem..
- Mon Dec 08, 2008 6:08 pm
- Forum: Problems / Questions
- Topic: Headlight Levels
- Replies: 8
- Views: 4886
Re: Headlight Levels
Why did you have to remove the lights??
Have you reconnected the motorised headlight units.
Have you replaced the light units, if so have you refitted the level motors correctly..
Do they go up and down when you move the level control switch.
etc etc etc
Have you reconnected the motorised headlight units.
Have you replaced the light units, if so have you refitted the level motors correctly..
Do they go up and down when you move the level control switch.
etc etc etc
- Sun Dec 07, 2008 9:58 pm
- Forum: Everything Else
- Topic: Engine Additives
- Replies: 1
- Views: 2268
Re: Engine Additives
It will actually say "check Injection".. This is a generic message and is not specific to the "injectors"..
Only a Diagnostics check will confirm the fault.. I guess this is a Diesel? in which case I would suspect 1 or more defective glow plugs as the likely problem..
Only a Diagnostics check will confirm the fault.. I guess this is a Diesel? in which case I would suspect 1 or more defective glow plugs as the likely problem..
- Fri Dec 05, 2008 6:06 pm
- Forum: Problems / Questions
- Topic: abs and service light on
- Replies: 4
- Views: 2831
Re: abs and service light on
Yup sounds like no ABS rings...
- Thu Dec 04, 2008 9:44 pm
- Forum: Problems / Questions
- Topic: ABS Light is ON - URGENT HELP REQ!!
- Replies: 6
- Views: 12248
Re: ABS Light is ON - URGENT HELP REQ!!
Connect the Diagnostic equipment.. Access the ABS computer.. go the the wheel speed indicators.. move the vehicle forward and you should get a speed reading off each wheel.. If there in no speed indicated on the repaired one then you have a problem.. It could be as I said above the bearing being pre...
- Thu Dec 04, 2008 9:36 pm
- Forum: Problems / Questions
- Topic: oil capacity of megane 1.9 dci
- Replies: 6
- Views: 10162
Re: oil capacity of megane 1.9 dci
4.8 inc filter if memory serves me well? 4.7 litres inc filter.. If it's the FAP fitted model then you MUST USE a 0W30 or 5W30 ACEA C3 oil, anything else can potentially knacker up the FAP filter There are some 5w40 C3 spec oils available now that are fine to use with FAP.. for example Castrol Magn...
- Tue Dec 02, 2008 8:43 pm
- Forum: Problems / Questions
- Topic: ABS Light is ON - URGENT HELP REQ!!
- Replies: 6
- Views: 12248
Re: ABS Light is ON - URGENT HELP REQ!!
The bearing has been fitted the wrong way round..
It is an "Active" ABS bearing and MUST be fitted the correct way or as you have found there will be no speed sensor signal....
It is an "Active" ABS bearing and MUST be fitted the correct way or as you have found there will be no speed sensor signal....
- Tue Dec 02, 2008 6:52 pm
- Forum: Problems / Questions
- Topic: Boot release problems.
- Replies: 3
- Views: 3248
Re: Boot release problems.
Lock and unlock the vehicle.. Then press and hold the boot release switch for 5 seconds to "reset" it..
- Sun Nov 30, 2008 4:17 pm
- Forum: Parts and Accessories
- Topic: Colour code location?
- Replies: 4
- Views: 12131
Re: Colour code location?
The paint code is on the left hand column and third number from the top of the "Oval" plate..
https://www.renaultbreakers.com/webpages ... 20main.htm
https://www.renaultbreakers.com/webpages ... 20main.htm
- Sun Nov 30, 2008 4:02 pm
- Forum: Problems / Questions
- Topic: Clutch pedal stuck down.
- Replies: 2
- Views: 3577
Re: Clutch pedal stuck down.
Sounds like the clutch master cylinder is defective.. Not uncommon.. and pretty easy to replace..
- Sun Nov 30, 2008 4:01 pm
- Forum: Parts and Accessories
- Topic: sump gasket
- Replies: 1
- Views: 2137
Re: sump gasket
What engine are you talking about here??
In anycase there is no "gasket" as such.. The sumps are sealed using Silicon adhesive..
In anycase there is no "gasket" as such.. The sumps are sealed using Silicon adhesive..
- Thu Nov 27, 2008 9:54 pm
- Forum: Problems / Questions
- Topic: 1.6 - r26 set up
- Replies: 4
- Views: 3045
Re: 1.6 - r26 set up
The 1.6 drive shafts will not locate correctly in the R26 hubs... and the R26 shafts will not fit in the 1.6 gearbox.. So that is gonna be a problem.. Along with the 1.6 brake master cylinder capacity being to small and unable to provide the fluid capacity for the Brembo calipers when you press the ...