Search found 52 matches

by dry_flood
Tue Feb 15, 2011 1:28 pm
Forum: Problems / Questions
Topic: Knock from OSF when going over bumps?
Replies: 22
Views: 18066

Re: Knock from OSF when going over bumps?

Mine was doing exactly the same.
One of the coil springs snapped so I had it replaced but it was till doing it. Had the shock absorber replaced and now it has stopped.

Cheers
Gaz
by dry_flood
Sat Oct 04, 2008 2:22 pm
Forum: Problems / Questions
Topic: Wet Carpets - Leaking Air Con Condensate
Replies: 9
Views: 11523

Re: Wet Carpets - Leaking Air Con Condensate

Are your PDF files in English?
by dry_flood
Sat Oct 04, 2008 2:12 pm
Forum: Problems / Questions
Topic: 1.9dci starting and then cutting out
Replies: 1
Views: 2484

Re: 1.9dci starting and then cutting out

where was the leak, My 1.5dci is suffering the same problem. I have to give it a good rev as soon as it fires or it cuts out. As soon as its running its fine but when I turn it off I can see the fuel running back down the pipe towards the tank.

Gaz
by dry_flood
Mon Aug 25, 2008 10:29 pm
Forum: Problems / Questions
Topic: 1.5 dci check injection cut out and wont start help
Replies: 4
Views: 10292

Re: 1.5 dci check injection cut out and wont start help

Shelldaz Yes the injectors have to be programmed to the car. Each injector has a serial number stamped on the side which must be programmed into the ecu. If you have replaced the injectors this could be a reason for it not starting. Although mine would start but ran very rough until they were progra...
by dry_flood
Mon Aug 25, 2008 10:21 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

Alex You are correct that the 1.5 doesnt have a low pressure pump. I was thinking exactly the same as you. The bubbles are before the priming bulb so I am going to disconnect the main fuel line and put the pipe that goes to the filter directly in a jerry can of diesel. If this cures the air/starting...
by dry_flood
Mon Aug 25, 2008 8:25 pm
Forum: Problems / Questions
Topic: 1.5 dci check injection cut out and wont start help
Replies: 4
Views: 10292

Re: 1.5 dci check injection cut out and wont start help

Have you pumped the fuel through? if you look at the picure below you will see a black priming bulb. Keep squeezing this to fill the fuel filter with diesel. This is the fuel line that feeds direct from the tank to the filter. Does it have air or fuel in it? http://i180.photobucket.com/albums/x304/d...
by dry_flood
Mon Aug 25, 2008 5:41 pm
Forum: FAQ / Tips & Tricks
Topic: How To: Check & Change Glow Plugs
Replies: 45
Views: 237488

Re: How To: Check & Change Glow Plugs

your all welcome. Now if only someone could shed some light on my latest issue http://www.meganeownersclub.co.uk/forum/viewtopic.php?f=2&t=6951&start=60

Gaz
by dry_flood
Sun Aug 24, 2008 8:36 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

Ok, I have had my car back for a week and am pleased to say that it runs great but..... it is having starting issues. If i hold the gas pedal down while starting it then it will start, give it a few revs and then it ticks over. If i do not hold the pedal then it starts but dies after a couple of sec...
by dry_flood
Sun Aug 24, 2008 7:56 pm
Forum: FAQ / Tips & Tricks
Topic: How To: Check & Change Glow Plugs
Replies: 45
Views: 237488

How To: Check & Change Glow Plugs

If you ever get the "check Injection" message on screen then this is the first thing to do before taking the car to a garage. Do this while the engine is fully warmed up, it will make it easier to remove the glow plugs if you need to change one. It is advisable to wear gloves as obviously ...
by dry_flood
Thu Aug 14, 2008 4:24 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

I have just been down and collected the 2 fault codes from the garage. DF052 & DF053 DF052 - circuit commande injecteurs - translates to "circuit orders injecting" anyone have any idea? DF053 - Rail Pressure Regulation Function The garage have ordered a new rail & sensor, anyone k...
by dry_flood
Thu Aug 14, 2008 3:20 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

I have just been down and collected the 2 fault codes from the garage. DF052 & DF053 DF052 - circuit commande injecteurs - translates to "circuit orders injecting" anyone have any idea? DF053 - Rail Pressure Regulation Function The garage have ordered a new rail & sensor, anyone kn...
by dry_flood
Wed Aug 13, 2008 10:29 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

ok so 2 weeks later and im still without a car. The garage have fitted the new injection pump and 4 new injectors. Primed it and it stared first time. They took it for a test drive and if you drive slowly or moderatley its fine but if you take it up between 4k - 4.5k revs it runs lumpy and goes into...
by dry_flood
Thu Jul 31, 2008 8:30 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

Well 1 month on and I suppose I owe you all an update. Since getting the car back my wife has racked up around 200 miles. We were going on holiday so the night before we were due to set off I went down to shell and filled the tank with their premium diesl (£73!!!!!! :eek. I travelled half a mile bef...
by dry_flood
Sun Jul 20, 2008 10:28 am
Forum: Problems / Questions
Topic: Resetting Engine management light after changing coils....an
Replies: 4
Views: 5713

Re: Resetting Engine management light after changing coils....an

Disconnect the battery for 45 mins and then reconnect. This will reset any error codes stored in the ecu. Just make sure you have your radio code. If you havent got it, you can ring a dealer and they will give it to you after you give them the reg etc. You may also need to reset the windows because ...
by dry_flood
Mon Jul 07, 2008 11:24 pm
Forum: Problems / Questions
Topic: Injection Fault & STOP 1.5 DCI
Replies: 159
Views: 229767

Re: Injection Fault & STOP 1.5 DCI

my issues were caused by contaminated fuel.

Gaz

Go to advanced search